Heated Vest Temperature Controller Holder

I have a heated vest that I use on my snowmobile for those cold days. It came with a Powerlet wireless temperature controller that I found difficult to adjust while I was riding as it would have to be stored in a pocket. so basically I would have to stop, remove my gloves and then open my pocket adjust it and then put it back in my pocket and then put my gloves back on. So I designed this simple case that clips onto the handlebar tree of the snowmobile and I can just turn the dial as I am riding to adjust it. I had to add a small plate to the handlebar tree for it to clip onto.

I have a Can Am Atv and wanted to be able to mount my GoPro cameras at various places on my machine. It seemed the logical way to be able to install them and remove them in seconds using this method. The files are actually hosted on my Thingiverse page as it was not an overly complicated design.

I needed to upgrade a project I have to a touch screen, I couldn't  find a case for what I needed so I decided to make my own. The case features internal pins to locate the Arduino and also some to locate the TFT. I didn't include any screws to hold the case together, I just put a dab of glue on each corner to hold it closed. 

There are two lower cases on with a hole for a cable and another without. If you want to use a different sizes hole I have included the Fusion 360 files.